Introduction
As with other components as time goes on we need more and more from each component, just a few years ago it was standard to have 128mb installed in your computer, but with each newer version of windows released required more and more memory. For example windows 95/98/ME would happily run on 128mb of memory, […]
When you get your case you need to check that you got all the bits. Open the case. Now that the case is open, now is a good time to go through the screw supply provided with the case. These are usually held in a small plastic bag nestled inside the case. Inside this bag […]
All ways be very careful when handling the processor. Always make sure you ground your self before touching the processor and motherboard. If you give the processor / motherboard a static shock you could break them. There are a few different types of processors. I am going to show you how to install a Pentium […]
Before you connect your motherboard to your case you need configure your motherboard for the processor/Memory/IO connectors. If we configure and install these components now it will be much easier than installing them after you have connected the motherboard to the case, You will have more room to work with now.
WARNING, make sure you […]
To perform a new install of Windows XP:
Insert your XP CD in the drive. It should automatically launch the Setup routine. If it doesn’t, click Start -> Run, type d:\setup.exe (where d: is the letter of your CD drive) in the Open box and click OK.
You’ll be presented with a menu of choices. Click Install […]
To perform a new install of Windows XP:
Insert your XP CD in the drive. It should automatically launch the Setup routine. If it doesn’t, click Start -> Run, type d:\setup.exe (where d: is the letter of your CD drive) in the Open box and click OK.
You’ll be presented with a menu of choices. Click Install […]
Now follow the following steps.
1) Make sure CD-Rom is first Boot Device in your Bios
2) Insert your Windows 2000 CD
3) Once this is done boot up using CD-Rom Drive.
( If your Hard drive is not setup then this is automatic, if not you will see “Hit any Key to Boot From CD-Rom” on the […]
Well for this I will show you the install for Microsoft Windows NT 4.0. Now follow the following steps.
Insert your Windows NT 4.0 CD and Disk 1 of your 3 NT Workstation setup disks
Once this is done boot up system.
The following “Hardware Configuration” will appear and Windows NT will detect your hardware […]
What you will require to do this walkthrough is
A Windows 98 CD
A Computer
Your Chosen CD-Rom Boot Media
The Microsoft Windows 98 Install will prepare to run a system check, after you have completed the routine for your CD-Rom boot and running the setup.exe file. Press enter to run the scandisk.
The “Windows 98 Setup” […]
What you will require to do this walkthrough is
A Windows ME CD
A Computer
Your Chosen CD-Rom Boot Media
Your Chosen Method
The Microsoft Windows ME Install will eventually run Scandisk, let this complete, if you exit windows will not allow you to complete the install of Windows ME.
The “Welcome to ME Setup” screen will […]